Installation guide

Configuring SCSI settings for the SIERRA™ plus film digitizer 1-13
VIDAR Film Digitizer Installation Guide
2. Set the digitizer’s SCSI termination.
The SIERRA™ plus is configured to be placed at the end of the SCSI
chain. The SCSI termination switch is on (termination activated).
Note:
VIDAR recommends that the Adaptec 2930CU SCSI
controller be used
only
for the digitizer. Do not connect internal
disk drives to the SCSI controller.
Note:
VIDAR does not recommend daisy-chaining multiple
SCSI devices with the film digitizer. If you are considering using
the digitizer in daisy-chain configurations, please first contact
VIDAR Technical Support ([e-mail]).
continued