User manual

Xact Application User Manual
Xact Application User Manual Page 17
Hardware Revision
Indicates the major and minor hardware revision numbers. Values range from 00
to FF hexadecimal (0-255 decimal). This is a read-only setting, and is shown in
the device management portal.
Vibration Motor Pattern
Sets the vibration pattern (rate at which vibration pulses are generated) for the
internal vibration motor. Values range from 1 to 9, each corresponding to a
particular pattern.
Power Down Disable
Indicates whether to disable the device buttons and use fake power-down mode.
Check the Power Down Disabled checkbox to disable the device buttons and use
fake power-down mode.
If sent directly to the device, the value is „Y‟ or „N‟.
Vibration Enable
Indicates whether to enable device vibration for geo-fence violations. Check the
Enabled checkbox to enable vibration when a geo-fence is violated.
If sent directly to the device, the value is „Y‟ or „N‟.
SOS Alert
Indicates whether to enable the SOS alert. The SOS alert is generated when a user
sponding
switch is pressed on the Xact Development Board.
Check the Enabled checkbox to enable the alert. If sent directly to the device, the
value is „Y‟ or „N‟.
Download Waypoints to Server
This defines the amount of waypoint data to download from the device. Choices
comprise All Data, 1 Week, 3 Days, 1 Day, 8 Hours, or 1 Hour.
Note that waypoints are initially written to the onboard memory, into a circular
buffer; they are not transmitted. See also Tracking Interval and Waypoint
Interval above.
If sent directly to the device, the value is an ASCII character, as follows: