User manual

Xact Application User Manual
Xact Application User Manual Page 13
Tracking Interval
Indicates an index corresponding to a time interval at which to transmit
waypoint/tracking information, selected by the spinner.
Configuration Editor
Direct to Device
0
1
2
3
4
5
6
7
8
9
A
B
C
D
E
F
”waypoint interval” – the device will send based
on waypoint interval on the device
5 seconds
10 seconds
15 seconds
30 seconds
45 seconds
1 minute
2 minutes
5 minutes
10 minutes
15 minutes
30 minutes
45 minutes
60 minutes
24 hours
Reserved
If sent directly to the device, the value is a decimal ASCII number.
For example, a setting of 8 indicates that the device should transmit waypoint
data every 5 minutes.
Motion Alert Threshold
A scalar motion threshold is set in this field and this represents a motion
threshold, when the detected motion level is exceeded (crosses the numeric
threshold, an event is generated and S-packet is immediately built and
transmitted to the referenced portal. An internal algorithm generates this
accelerometer scalar motion level 

root is taken of the resultant motion levels.

The checkbox Alarm operates WITHOUT geofences is used to indicate whether
the motion alert is associated with the geofences or if the motion alarm is
operating independently.
The most significant bit (MSB) indicates if the motion alert is associated with the
geofences or if the motion alarm is operating independently. If the MSB is 0, the