User manual

Xact Application User Manual
Xact Application User Manual Page 11
This chapter describes all the data fields and controls in the Configuration Editor
 the window revealed when the Open Editor button is pressed in the main
application window. For each setting, values are given both for choices within the
Configuration Editor and for sending data directly to the device.
Send Acknowledgement to Server
Checking this checkbox forces the configuration to be recorded. The
configuration packet is sent to the device, and a return code is sent to the server.
If sent directly to the device, the value is „Y‟ or „N‟. „Y‟ indicates that the
configuration packet has been accepted and loaded. If the packet was malformed
or incorrect, the packet is sent back with this set to 'N'.
Fence Number
The Xact Development Board and Xact Trax device allow you to define geo-fences
within a management portal (essentially soft fences) or on the device itself.
The Configuration Editor enables a number of fence-related settings to be
changed; for example, the fence direction, days active, fence latitude/longitude
coordinates, and active fence start and stop times. For these settings, the fence to
which they apply must be indicated, and this is done here.
Select a fence number in the spinner. Up to 50 hardware fences are available.
If sent directly to the device, the value is a hexadecimal ASCII number, from
0x00 to 0xFF.
SMS or GPRS
Indicates the roaming mode (allowed or not) and whether SMS is enabled as a
fallback mechanism. Values are as follows, selected from the drop-down list: