User manual

GHI Electronics,LLC Embedded Master User Manual
GHI Loader
4. In the terminal window keep sending “%” character continuously and quickly. Note
the quotes are used here just to isolate the character. Also, instead of using the “%”
key, this can be done by holding the Up, Down and Select buttons.
5. While doing step 4, reset Embedded Master Module. If using the development
system then press the reset button.
6. After pressing reset while sending “%” and with under a second, the terminal should
show BL and will keep sending BL for every character entered.
7. If at this point you do not see BL and you get BL for every key press then do not
proceed. Go back and check the steps again.
8. Enter V (upper case) and you will see back the GHI loader version number
9.2. GHI Loader Commands
GHI Loader has few simple commands. All commands and entries must be entered
in upper case or they will not work.
Rev. 2.06 TFT Page 54 of 102 www.ghielectronics.com