User manual

GHI Electronics,LLC Embedded Master User Manual
Getting Started with Embedded Master
We recommend that you run the driver installer above before plugging in the device.
6.6. Development System First Power-up
The development system comes loaded with the latest firmware and pre-loaded with an
example application. Power up the device using a power pack or a USB cable and you will
see the example running on the LCD. The user will have some options, for example,
testing USB Host features by plugging in a mouse or a joystick...etc.
Important Note: If you are currently using a development system with older firmware
version 01.08.0000 or older - with .Net Micro Framework 2.5 or older, please update the
firmware to 3.0 releases. Upgrading is a separate document.
Once the system is tested for functionality, try to deploy your own application.
1. Power Up the development system board.
2. on the Display you will see the debugging interface. which is USB in GHI firmware
with Net Micro Framework 3.0 release.
Look for “DBG: USB”
Note: User can change the debugging interface.
3. Connect USB cable to X3 on one end and to your PC on other end.
Rev. 2.06 TFT Page 40 of 102 www.ghielectronics.com
X1
Virtual COM USB Connector
Interfacing UART0 port
X3
USB Debugging Interface