User manual

GHI Electronics,LLC Embedded Master User Manual
Getting Started with Embedded Master
Once the USB cable is plugged in, windows will ask for drivers. The drivers are in the
Embedded Master SDK. For example, on this PC they are in
%Embedded Master SDK Folder%\USB Debugging Drivers\GHIMFInterface.inf
A snap shot from Device Manager after installing the driver
Important Note: The Development System can not be powered through this USB
connector.
6.5. Virtual COM Setup
Embedded Master Development System interfaces the first UART port of Embedded
Master Module into USB Virtual COM - in the lower right corner (X1) -.
Once the USB cable is plugged in, windows will ask for drivers. The drivers are in the
Embedded Master SDK. For example, on this PC they are in
%Embedded Master SDK Folder%\Virtual COM Port Driver/SDM 2.02.04.exe
Rev. 2.06 TFT Page 39 of 102 www.ghielectronics.com