Integration Guide
Table Of Contents
- Important Notice
- Safety and Hazards
- Limitation of Liability
- Patents
- Copyright
- Trademarks
- Contact Information
- Revision History
- 1: Introduction
- 2: Power
- 3: RF Specifications
- 4: Routing Constraints and Recommendations
- 5: Regulatory Compliance and Industry Certifications
Regulatory Compliance and Industry Certifications
Rev 2 Feb.16 23 Specifications subject to change
5. A label must be affixed to the outside of the end product into which the
AirPrime WP8548 module is incorporated, with a statement similar to the
following:
ยท This device contains FCC ID: N7NWP8 / IC:2417C-WP8.
6. A user manual with the end product must clearly indicate the operating
requirements and conditions that must be observed to ensure compliance
with current FCC
/ IC RF exposure guidelines.
The end product with an embedded AirPrime WP8548 module may also need to
pass the FCC Part 15 unintentional emission testing requirements and be
properly authorized per FCC Part 15.
Note: If this module is intended for use in a portable device, you are responsible for
separate approval to satisfy the SAR requirements of FCC Part 2.1093 and IC RSS-102.