Integration Guide
Table Of Contents
- Important Notice
- Safety and Hazards
- Limitation of Liability
- Patents
- Copyright
- Trademarks
- Contact Information
- Revision History
- 1: Introduction
- 2: Power
- 3: RF Specifications
- 4: Routing Constraints and Recommendations
- 5: Regulatory Compliance and Industry Certifications
Regulatory Compliance and Industry Certifications
Rev 1 Apr.16 23 Specifications subject to change
· The radiated power of a collocated transmitter must not exceed the EIRP
limit stipulated in
Table 5-2.
5. A label must be affixed to the outside of the end product into which the
AirPrime WP7504 module is incorporated, with a statement similar to the
following:
· This device contains FCC ID: N7NWP7 / IC:2417C-WP7.
6. A user manual with the end product must clearly indicate the operating
requirements and conditions that must be observed to ensure compliance
with current FCC
/ IC RF exposure guidelines.
The end product with an embedded AirPrime WP7504 module may also need to
pass the FCC Part 15 unintentional emission testing requirements and be
properly authorized per FCC Part 15.
Note: If this module is intended for use in a portable device, you are responsible for
separate approval to satisfy the SAR requirements of FCC Part 2.1093 and IC RSS-102.
Table 5-2: Collocated Radio Transmitter Specifications
Device Technology Frequency
(MHz)
EIRP Limit
(dBm)
Collocated
transmitters
1
1. Valid collocated transmitter combinations: WLAN+BT; WiMAX+BT.
(WLAN+WiMAX+BT is not permitted.)
WLAN 2400–2500 25
5150–5850 27
WiMAX 2300–2400 25
2500–2700 25
3300–3800 25
BT 2400–2500 15