User guide

Installation and Startup

Rev 2 Jun.13 29

•Both (AP + Client Mode) where the device can act as an AP and also use a

Wi-Fi Client connection to connect to an AP

The GX Series device connects as a client to a configured AP whenever the

AP is available. When the AP is not available, it connects to 3G, all the while

the device acts as a AP to W-Fi clients connected to the GX.

See the ALEOS Configuration User Guide for details on Wi-Fi set up and use.

I/O X-Card

This card uses a 15-pin connector to add to the basic device:

• One additional RS-232 communication port

• Four additional digital I/O pins

• Four analog voltage sensing pins

See the ALEOS Configuration User Guide for details on I/O set up and use.

I/O X-Card 15-Pin Connector Description

Figure 2-10: I/O X-Card 15-pin Connector Pin Diagram

Table 2-3: I/O 15-Pin Connector Pin Description

Pin Description Pin Description

1 RS-232 TXD Output 9 Reserved for future use

2 RS-232 RTS Output 10 Ground

3 Digital I/O 2 11 Digital I/O 3

4 Digital I/O 4 12 Digital I/O 5

5 RS-232 RXD Input 13 Reserved for future use

6 RS-232 CTS Input 14 Analog Input 1

7 Analog Input 2 15 Analog Input 3

8 Analog Input 4 NOTE: This is not a VGA connector

131415 12 11

10 9

432