User guide

AirLink GX Series User Guide
24 4114008
Reset to factory default settings
To reset the device to the factory default settings:
1. Press and hold the Reset button until all the LEDs start flashing yellow (about
30–45 seconds). See Front Panel on page 10.
The device reboots. Once the reboot is complete and the LEDs resume their
normal operating behavior, the reset is complete.
Power Connector Description
The GX Series device’s power connector is a four pin connector that has:
• Two pins connecting DC voltage to the device
• Two pins providing additional monitoring and control functions
This section has information to help you plan your device’s connection and
configuration.
The connector’s pin diagram is shown below. It also shows the colors of the wires
used on the DC power cable you can order from Sierra Wireless.