User guide

Installation and Startup
Rev 2 Jun.13 23
Operating
Ethernet LEDs
The Ethernet connector has two LEDs that indicate speed and activity. When
looking into the connector:
• Activity— The right LED is solid yellow when a link is detected (the cable is
plugged in) and blinks when there is activity.
• Connection Speed—The left LED is green to indicate a 100 Mbps connection
and orange to indicate a 10 Mbps connection. It is off when no cable is
connected.
Color Network LED Signal LED Activity LED Power LED
Off — — Normal operation No power or
input voltage
≥
36VDC or ≤
9VDC
Solid Green Network Ready—
(LTE service for GX440)
Good signal
(RSSI
≥ -85 dBm)
— Device is
connected to
nominal power
and is operating
normally
Flashing:
Yellow (0.5 sec.) /
Green (1.0 sec.)
Network Ready—
(No LTE service for
GX440)
— — Device has a
GPS fix
Flashing Green
(1.0 sec. on/0.5 sec. off)
Network Ready—Roaming — Radio is
transmitting or
receiving
—
Flashing:
Yellow (0.5 sec.) /
Green(0.5 sec.) /
Off (0.5 sec.)
Network Ready—Roaming
(No LTE service for
GX440)
— — —
Flashing Green
(3 sec. on/1 sec. off)
Network Ready—WAN
over Wi-Fi (device in Wi-Fi
client mode)
— — —
Flashing Yellow
(0.8 sec. on/0.8 sec. off)
No Service — — —
Solid Yellow Connecting to the network Marginal signal
(-100 dBm < RSSI
< -85 dBm)
— Device entering
low power mode
or system low
level boot
Flashing Red
(0.7 s on/2.3 s. off)
Authentication/Negotiation
failed
No signal
(RSSI
≤-110 dBm)
— —
Solid Red Link Down
No cellular network is
present or the device is in
radio passthru mode
Poor signal
(-110 dBm < RSSI
< -100 dBm)
— Device not
operational
(failure or in low
power mode)