Specifications

AirPrime UMTS / LTE MC/SL-Series Extended AT Command Reference
44 Proprietary and Confidential 2130616
!CUSTOM
(continued)
Set/query customization settings (continued)
• “PRLREGION”—Region-specific scanning algorithm.
<value>:
• 0 = Default (internal)
• 1 = Europe/rest of the world
• 2 = North America
• 3 = Australia
• 4 = Japan
• 5 or greater = Reserved
• “PUKPRMPT”—Indicate if host will prompt for PUK code if maximum number of
PIN unlock retries is exceeded.
<value>:
• 0 = Don’t prompt
• 1 = Prompt
• “RADIORESET”—Indicate if modem should reset when coming out of Low
Power Mode (that is, if +CFUN=1). (Note: Not supported by MDM9200)
<value>:
• 0 = No reset (default)
• 1 = No reset
• 2 = Reset
• “RFINDENABLE” (MC8795V with GPS-enabled only)—Enable/disable RF
indicator for DIO-3 and DIO-4, showing GPS ON/OFF status and operating
band.
<value>:
• 0 = Disable (Default)
• 1 = Enable
• When enabled:
DIO-3 (GPS status): 0 = GPS disabled; 1 = GPS enabled
DIO-4 (Operating band): 0 = 850/1900; 1 = 900/1800/2100
• “SCANPROF”—Enable/disable profile scan (try all profiles configured on card
until successful connection is found; the activated context becomes the new
default).
<value>:
• 0 = Disable
• 1 = Enable
• “SIMLPM”—Indicate default SIM power state during Low Power Mode.
<value>:
• 0 = Default (device-dependent)
• 1 = Do not power down SIM in LPM
• 2 = Power down SIM in LPM
(Continued on next page)
Table 3-2: Modem status, customization, and reset commands (Continued)
Command Description