Specifications

Modem Status, Customization, and Reset Commands
Rev. 8 May.12 Proprietary and Confidential 41
!CUSTOM
(continued)
Set—query customization settings (continued)
• “CSVOICEREJECT”—Enable/disable ability to ignore incoming voice call pages
on 3G channels.
<value>:
• 0 = Process pages as per 3GPP TS 24.008 specification (default)
• 1 = Ignore paging (type 1 and 2) messages
• 2 = Reject call setup (voice and circuit-switched VT), returning cause code 88
(Incompatible destination)
• “DISFDNPDPCHK”—Enable/disable FDN check for PS data calls.
<value>:
• 0 = Allow FDN checking
• 1 = Disable FDN when checking PDP activation number
• 2 = Disable FDN when checking SMSC address
• 3 = Disable FDN when checking PDP activation number and when checking
SMSC address
• “DISSTACK”—Enable/disable Adaptive Multi-Rate (AMR) codec
<value> (Bitmask):
• 00000000 = (Default) Enable AMR, including AMR-WB
• 00001000 = Disable AMR, including AMR-WB
• 00010000 = Disable AMR-WB only
• “GPSENABLE”—Enable the Mobile Originated (MO) and/or Mobile-Terminated
(MT) GPS feature (and present the NMEA port to the host).
<value>:
• 0 = Disable
• 1 = MT & MO enabled
• 2 = MO enabled only
• 3 = MT enabled only
• (MDM9200 3.0 release 2 or higher)
4 = NMEA port enabled; MT & MO enabled (unless GPS_DISABLE pin is
asserted)
• (MDM9200 3.0 release 2 or higher)
5 = NMEA port enabled; MO enabled (unless GPS_DISABLE pin is asserted)
• (MDM9200 3.0 release 2 or higher)
6 = NMEA port enabled; MT enabled (unless GPS_DISABLE pin is asserted)
• “GPSLPM”—Enable/disable GPS in Low Power Mode.
<value>:
• 0 = Enable (Default)
• 1 = Disable
• “GPSREFLOC”—Enable/disable reference GPS location reporting.
<value>:
• 0 = Enable (Default)
• 1 = Disable
(Continued on next page)
Table 3-2: Modem status, customization, and reset commands (Continued)
Command Description