Specifications

AirPrime UMTS / LTE MC/SL-Series Extended AT Command Reference
40 Proprietary and Confidential 2130616
!CUSTOM
Supporting chipsets:
• All
Note: Some customizations
may not be available for
certain chipsets, firmware
revisions, or devices.
Set/return customization settings
Set or return several customization values.
Usage:
• Execution: AT!CUSTOM=<customization>, <value>
Response:
OK
Purpose: Assign <value> to a specific <customization> setting.
• Query: AT!CUSTOM?
Response:
(list of enabled <customization>s)
OK
Purpose: Display customizations that are currently enabled.
• Query list: AT!CUSTOM=?
Purpose: Return a list of valid <customization> values.
Parameters:
<value> (Value being assigned to a specific <customization> setting)
• Descriptions are included in each of the customizations described below.
• Numeric value. Valid range depends on the <customization> type.
<customization> (String identifying customization setting. The default value for all
customizations is 0.)
Note: Use quotation marks around the customization string. For example,
AT!CUSTOM=”CSDOFF”,0.
• “AUTONETWORKMODE“—Indicate if UE should revert to Automatic Network
mode after 60 seconds of Manual Network mode.
<value>:
• 0 = Remain in Manual.
• 1 = Revert to Automatic.
• 2 = Remain in Manual if UE is attached to the network, otherwise switch to
Automatic.
• “CFUNPERSISTEN“—Enable/disable persistence (across power cycles) of
AT+CFUN setting.
<value>:
• 0 = Disable (+CFUN setting does not persist across power cycle)
• 1 = Enable (+CFUN setting persists across power cycle)
• “CPASCWRINGIND”—Set incoming (RINGING) vs. in-progress call priority for
+CPAS command.
<value>:
• 0 = Incoming call does not take priority over a call already in progress
(Default)
• 1 = Incoming call takes priority over a call already in progress
• “CSDOFF“—Enable/disable ability of UE to initiate CS calls.
<value>
• 0 = Enable
• 1 = Disable
(Continued on next page)
Table 3-2: Modem status, customization, and reset commands (Continued)
Command Description