Specifications

Modem Status, Customization, and Reset Commands
Rev. 8 May.12 Proprietary and Confidential 37
!BSMCCHECK
Supporting chipsets:
All
Note: This command is not
password-protected.
Return modem hardware version
Return the modem’s hardware (board) version number based on the hardware resistor.
A similar command, ^HVER, returns the version number based on the FSN (see the
UMTS Modems Supported AT Command Reference, Document 2130617).
For MC879xV, use ^HVER.
Usage:
Query: AT!BSMCCHECK?
Response:
<hwRev>
OK
Purpose: Return the modem’s <HW ID value>.
Parameters:
<version> (Modem’s hardware version)
Valid values:
”ENG1_1” – Modem uses an Eng 1.1 board
“ENG2_0” – Modem uses an Eng 2.0 board
“SPR1_D” – Modem uses an SPR 1D board
“SPR1_V” – Modem uses an SPR 1V board
“ENGXXX” – Modem uses a newer board that cannot be identified by the
current firmware version
“PCB_ID_x”MDM8200 devices only. (‘x’ is the hardware revision level)
Table 3-2: Modem status, customization, and reset commands (Continued)
Command Description