Specifications

About This Guide
Rev. 8 May.12 Proprietary and Confidential 25
Conventions
The following format conventions are used in this reference:
Character codes or keystrokes that are described with words or standard
abbreviations are shown within angle brackets using a different font, such as
<CR> for Carriage Return and <space> for a blank space character.
Numeric values are decimal unless prefixed as noted below.
Hexadecimal values are shown with a prefix of 0x, i.e. in the form 0x3D.
Binary values are shown with a prefix of 0b, i.e. in the form 0b00111101.
Command and register syntax is noted using an alternate font:
!CHAN=<c>[,b].
The leading “
AT” characters are not shown but must be included before all
commands except as noted in the reference tables.
Characters that are required are shown in uppercase; parameters are noted in
lowercase. Required parameters are enclosed in angle brackets (
<n>) while
optional parameters are enclosed within square brackets (
[x]). The brackets are
not to be included in the command string.
Commands are presented in table format. Each chapter covers the commands
related to that subject and presents a summary table to help you locate a needed
command. Commands are in ASCII alphabetical order in the body of each
chapter.
Any default settings are noted in the command tables. Note that these are the
factory default settings and not the default parameter value assumed if no
parameter is specified.
!SARSTATE Set/report SAR backoff state 262
!SARSTATEDFLT Set/report default SAR backoff state 262
!THERMCONFIG Set/report thermal mitigation configuration options 263
!THERMDELTATX Set/report amount to reduce maximum Tx power 264
!THERMDELTATXTEMP Set/report amount power backoff temperature threshold 265
!THERMENABLE Enable/disable thermal mitigation 265
!THERMINFO Display thermal mitigation information 266
!THERMTHRESHOLD Set/report thermal threshold, mitigation threshold, and
hysteresis
267
!THERMTIMERS Set/report thermal mitigation algorithm timer details 268
Table 1-13: SAR backoff and thermal control commands (Continued)
Command Description Page