Specifications

GPS Commands
Rev. 8 May.12 Proprietary and Confidential 191
!GPSNIQOSTIME
Supporting chipsets (GPS-
enabled devices only):
• MDM6200
• MDM8200A
• MDM8220
• MDM9200
• MDM9600
• MSM6290
• QSC6270 (min f/w rev: S2.0)
Set/report GPS QoS timeout period for network-initialized fixes
Set or report the current GPS QoS timeout period for network-initiated fixes.
Note: !RESET must be issued after this command is used.
Usage:
• Execution: AT!GPSNIQOSTIME=<timeout>
Response:
OK
or ERROR
Purpose: Set the new timeout period.
• Query: AT!GPSNIQOSTIME?
Response:
QoS time: <timeout>
OK
Purpose: Return the current <timeout> period.
Parameters:
<timeout> (GPS QoS timeout period)
• Timeout period (in seconds)
!GPSNMEACONFIG
Supporting chipsets (GPS-
enabled devices only):
• MDM6200
• MDM8220
• MDM9200
• MDM9600
• MSM6290
• QSC6270 (min f/w rev: S2.0)
Enable and set NMEA data output rate
Enable or disable NMEA data output, and set the output rate for use with
!GPSTRACK.
Usage:
• Execution: AT!GPSNMEACONFIG=<enable>[,<outputRate>]
Response:
OK
or ERROR
Purpose: Enable or disable NMEA output and set rate.
• Query: AT!GPSNMEACONFIG?
Response:
Enabled: 0
Output Rate: <outputRate>
or Enabled
Output Rate: <outputRate>
OK
Purpose: Return the current <timeout> period.
• Query List: AT!GPSNMEACONFIG=?
Purpose: Return valid parameter values.
Parameters:
<enable> (Enable/disable NMEA data output)
• 0=Disable. (Note: <outputRate> is ignored)
• 1=Enable. (Note: <outputRate> is required)
<outputRate> (NMEA data output rate—time between outputs)
• Valid range: 1–255 seconds
Table 9-2: GPS command details (Continued)
Command Description