Specifications

GPS Commands
Rev. 8 May.12 Proprietary and Confidential 187
!GPSLBSAPN
Supporting chipsets (GPS-
enabled devices only):
• MDM9200 (min f/w rev:
SWI9200X_03.00.10.00;
SWI9200X_03.05.04.01)
Set GPS LBS APNs
Set the GPS LBS APNs to be used for various RATs (Radio Access Technologies).
Usage:
• Execution (Add):
AT!GPSLBSAPN=<operation>,<ratmask>,<IPtype>,<APN>
Execution (Delete one):
AT!GPSLBSAPN=<operation>,<ratmask>
Execution (Delete all):
AT!GPSLBSAPN=<operation>
Response:
OK
or ERROR
Purpose: Set the APN to be used for the specified <ratmask>, or delete the
APN for a single <ratmask> or all RATs.
• Query: AT!GPSLBSAPN?
Response: <operation>, <ratmask>, <IPType>, <APN>
<operation>, <ratmask>, <IPType>, <APN>
...
OK
or OK (if no ID has been set)
Purpose: Display the APNs currently assigned for each RAT.
• Query List: AT!GPSLBSAPN=?
Purpose: Display valid parameter options.
Parameters:
<operation> (Add or delete APNs)
• 1=Add an APN for a specific <ratmask> and <IPtype>.
Note: All paramters are required.
Note: To change an APN that has been set for a RAT, you must first delete the
current APN, then add the new APN.
• 2=Delete the APN for a specific <ratmask>
Note: Only <ratmask> is required.
• 3=Delete all APNs
Note: No other parameters are required.
<ratmask> (Radio access technology)
• Valid values (values shown are in hexadecimal format):
• 01=CDMA
• 02=HDR
• 04=GSM
• 08=WCDMA
• 10=LTE
(Continued on next page)
Table 9-2: GPS command details (Continued)
Command Description