Specifications

Rev. 8 May.12 Proprietary and Confidential 179

9: GPS Commands

Introduction

This chapter describes commands used to access GPS functionality

in supporting modules.

When using these commands, the following considerations apply:

• GPS is typically enabled by default; however, it may be disabled

by default for some SKUs. If so, enable GPS using

AT!CUSTOM=”GPSENABLE”

• If supported by the modem, gpsOneXTRA is enabled (over the

NDIS interface) by default when GPS is enabled, and it

generates data traffic.

Command summary

The table below lists the commands described in this chapter.

Table 9-1: GPS commands

Command Description Page

!GPS3RDPARTYXFER Initiate Location Service (LCS) third party transfer location

request

181

!GPSAUTOSTART Configure GPS auto-start features 182

!GPSCLRASSIST Clear specific GPS assistance data 183

!GPSCOLDSTART Clear all GPS assistance data 184

!GPSEND End an active session 184

!GPSFIX Initiate GPS position fix 185

!GPSIPADDR Set/report IP address to use over TCP/IP 186

!GPSKEEPWARM Configure Keep Warm functionality 186

!GPSLBSAPN Set GPS LBS APNs 187

!GPSLBSSETTINGS Set default GPS location fix options 188

!GPSLOC Return last known location of the modem 189

!GPSMTLRSETTINGS Set/report MT location request settings 190

!GPSNIQOSTIME Set/report GPS QoS timeout period for network-initialized

fixes

191

!GPSNMEACONFIG Enable and set NMEA data output rate 191

!GPSNMEASENTENCE Set/report NMEA sentence type 192