Specifications

Voice Commands
Rev. 8 May.12 Proprietary and Confidential 151
!AVSETPROFILE
Supporting chipsets (voice-
enabled devices only):
• MDM6200
• MSM6290 (min f/w rev:
K1_0_1_0ap)
• QSC6270 (min f/w rev: S2.0)
Note: For MDM8200A, see
!AVSETPROFILE on page 174.
Configure and activate profile
Select a profile with which to establish a circuit-switched call. (See “Profile activation”
on page 130.) This command also enables / disables muting on the earpiece and
microphone and sets the volume level.
The profile you select remains active until the modem is reset or powered down and
up again. Following a reset or power up, Profile 0 (the default profile) is active.
If desired, you can run the command !AVRXVOLDB on page 150 to assign specific
volume levels to each of the predefined volume levels, 1 through 7.
Usage:
• Execution: AT!SETPROFILE=<profile>, <earmute>, <micmute>,
<generator>, <volume>[, <cwtmute>]
Response: OK
Purpose: Set the audio characteristics for the specified <profile>.
• Query: AT!AVSETPROFILE?<generator>
Response:
<profile>, <earmute>, <micmute>, <volume>
OK
Purpose: Return the audio profile characteristics for the specified audio type
(<generator>).
Parameters:
<profile> (Audio profile number)
• MSM6290, QSC6270:
• 0=Handset
• 1=Headset
• 2=Car kit
• 3=Speaker phone
• 4=Auxiliary
• 5=TTY
• 6=Auxiliary external PCM (128 kHz clock)
• 7=Primary external PCM (2 MHz clock)
• MDM6200:
• 7=Primary external PCM (2 MHz clock)
<earmute> (Enable/disable earpiece muting)
• 0=Unmuted
• 1=Muted
<micmute> (Enable/disable microphone muting)
• 0=Unmuted
• 1=Muted
<generator> (Audio type)
• 0=Voice
(Continued on next page)
Table 7-5: Voice command details (Continued)
Command Description