Specifications

Rev. 8 May.12 Proprietary and Confidential 13
1
1: About This Guide
Introduction
This document describes proprietary, password-protected AT
commands available for Sierra Wireless AirPrime™ MC/SL-series
intelligent embedded modules. These commands are intended for
use by OEMs, and are supplemental to the standard AT commands
for GSM devices defined by the 3GPP (3rd Generation Partnership
Project) in TS 27.007 AT command set for User Equipment (UE) and
TS 27.005 Use of Data Terminal Equipment—Data Circuit
terminating Equipment (DTE-DCE) interface for Short Message
Service (SMS) and Cell Broadcast Service (BSE).
The Sierra Wireless document UMTS Modems - Supported AT
Command Reference (document number 2130617) identifies
supported standard AT commands and provides details where
commands vary from the standards. It also describes proprietary
commands that are not password-protected.
Note: If a command is only partially protected (for example, the execution
form is restricted, but the query form is not), the non-protected form of the
command also appears in the ‘Supported’ reference.
The AT commands in this document are specific to the Sierra
Wireless embedded modems listed in Table 1- 1.
Table 1-1: Supported AirPrime modules
a
Chipset Device Firmware revision (minimum)
b
MDM6200 SL809X P0.0
MDM6270 SL8081
c
SL8083
c
SL8085
c
S2.0.0.9
MDM8200 MC8700 M2_0_4_0ap
MDM8200A MC8704
MC8705
(MC8704) T2_0_1_4
(MC8705) T1_0_1_1
MDM8220 MC8801 N_0_0_0ap
MDM9200 MC7700
MC7710
9200X_01.00.00.00
MDM9600 MC7750 9600M_01.00.00.00