Specifications

Test Commands
Rev. 8 May.12 Proprietary and Confidential 101
!DAGINFO
Supporting chipsets:
• All
Note: The modem must be in
online mode to use this
command.
Return GSM mode RF information (GSM only)
Return RF information for GSM mode.
Note: !DAWINFO provides RF information for WCDMA mode.
Usage:
• Execution: AT!DAGINFO
Response:
Channel: <channel> RSSI:<rssi> LNA:<lna> RXPWR:<rxPwr>
dBm SNR:<snr> DC Offset_I:<iOffset> DC Offset Q:<qOffset>
Freq. Offset:<freqOffset> Timing Offset:<timingOffset>
OK
Purpose: Return the RF information.
Parameters
<channel> (GSM channel)
• Valid range: 0–65535
<rssi> (Receive power)
• Valid range: 0x00000000–0xFFFFFFFF
<lna> (LNA gain state)
• Valid range: 0–65535
<rxPwr> (Rx power in dBm (0.25 units))
• Valid range: 0–65535
<snr> (Signal-to-noise ratio)
• Valid range: 0–65535
<iOffset> (I offset)
• Valid range: 0–65535
<qOffset> (Q offset)
• Valid range: 0–65535
<freqOffset> (Frequency offset)
• Valid range: 0–65535
<timingOffset> (Timing offset)
• Valid range: 0–65535
!DAGSLOCK
Supporting chipsets:
• All
Note: The modem must be in
FTM mode to use this
command—use
!DAFTMACT
to enter FTM mode.
Return synthesizer lock state
Return a value indicating the lock state of the RF synthesizers.
Usage:
• Execution: AT!DAGSLOCK
Response:
<sLockState>
OK
Purpose: Return the synthesizer lock state.
Parameters
<sLockState> (Synthesizer lock state)
• 0=One or more synthesizers are out of lock
• 1=All synthesizers locked
Note: !DASBAND and !DASCHAN must be issued before you can use !DAGSLOCK .
Table 5-2: Test command details (Continued)
Command Description