User guide

Configuring your Raven XT
Rev 3.0D Jul.09 37
b. Toseewhatyouare typingasyoutypeit,youwill
needtoturnontheechoand verbosemode.Type
ATE1V1andpressEnter.
c. Ifyougetareplyof“OK”,thenyouenteredthe
commandsuccessfully.Ifyougetareplyof“0”or
“ERROR”,tryenteringthecommandagain.
AT Commands
Whenusingaterminalapplication,youwillneedtomanually
typeineachcommand.
• Formostcommands,whenyouareenteringthemusinga
terminalconnection,youwillneedtoprefacethe
commandwithAT(exceptionsarenoted),i.e.AT Awhich
islistedasA.
• Somecommandshavespecificparameterswhileother
commandswilltakewhateveryoutype.
• Requiredvariableparametersaredenotedwithitalicized
text,example,Dn.Thenisvariable.
• Acceptableparametersand/orspecificformatsarelisted
witheachcommand.
• Mostcommandswithparameterscanbeenteredwith?to
readthecurrentvalue(forexample,AT&D?willrespond
with“2”ifthedefaulthasnotbeenchanged).
• Optionalparametersaredenotedwithsquarebrackets[].
• ATCommandsarenotcasesensitive.Acapital“E”isthe
sameasalower‐case“e”.
• Whenyouareusingaterminalconnection,ifyouentera
commandwhichisrecognizedbytheRavenXT,itwill
respondwith“OK”.Ifthecommandisnotrecognized,the 
responsewillbe“ERROR”.
• Thosecommandsapplicableonlytocertainmodel
numbersoftheRavenXTwillbenoted.
Caution: Symbols listed with commands, such as *, /, &, or ?, are
part of the command and must be included. Commands with symbols
other than * may require PassThru mode.