User guide

Hardware Installation of the Raven XT
Rev 3.0D Jul.09 21
seconds(count10slowly,andwaitforthepowerlightto
gooffafterthelightpatternstops),theALEOSconfigu
‐
rationsettingswillreturntothefactorydefaults.
Light Patterns
TheLEDsonthefrontofthemodemwillrespondindifferent
patternstoindicatemodemstates.
• Normal‐EachLED,mentionedabove,islitasapplicable.
• Startup‐TheLEDswillcyclefromlefttoright.
• PassThrumode‐NetworkandSignalLEDswillblinkin
tandem.TheActivityLEDwillblinkwhentran smittingor
receivingdata.
• SOS‐TheNetworkLEDblinks.
• ConfigurationReset‐TheLEDswillcyclelefttorightand
thenrighttoleft4times.
• AuthenticationFailure‐TheNetwork,Signal,and
ActivityLEDsblinkevery2seconds.
• DataRetry‐TheNetwork,Signal,andActivityLEDsblink
every3seconds.
Mounting
AnoptionalaccessoryforyourRavenXTisamountingkit,
whichincludesabracket.Thebracketisdesignedtosnugly
cradlethemodemandholditinplacewhereyouneedit.You
canuseastraparoundthebracketandmodemforextra
security.Thebracketcanbeattached
toastationarylocation
using#6screwswiththemountingholediameterapproxi
‐
mately0.150ʺ.
Theinstructionstobracketinstallationisfollowing:
1. Mountthebracketusingnumber6screws.Therearetwo
holeseach,tofastenscrews,andminimumofonehole
eachendisrequiredformountingbracket.
2. PositionRavenXTbetweenAlignmentears.
3. EngagetopgrooveinbodyofRavenXTwithtwotabs.
4. PushonfarsideofRavenXTincentersothatittouches
sideofBracket.
5. Pressdownandreleasewhenuppergrooveonfarsideof
RavenXT,alignswithtabs.
6. Releasetocompleteinstallationintomountingbracket.
Caution: If you reset the modem configuration using the reset button,
you may need to reactivate your Raven XT with your cellular provider.