User guide

Activating your Raven XT on your cellular provider
Rev 3.0D Jul.09 15
Note: These AT commands are
only needed if your cellular
account supports Private
Networking . Not all of the
parameters are required.
Please check with your carrier,
which parameters need to be
set.
1. Putmodemintopassthrumode.
AT\APASSTHRU
2. VerifyyouareinPassthrumode.
AT!STATUS
3. SettheNAI.
AT$QCMIPNAI=[NAI],1
4. SettheIPaddressoftheprimaryhomeagent.
AT$QCMIPPHA=[PHA_IP],1
5. SettheIPaddressofthesecondaryhomeagent.
AT$QCMIPSHA=[SHA_IP],1
6. Setthehomeagentsharedsecretkey.
AT$QCMIPMHSS=oursecretmnhakey,1
7. SettheAAAsharedsecretkey.
AT$QCMIPMASS=[AAA_Key],1
8. Enablereversetunneling.
AT$QCMIPRT=1,1
9. EntertheSPItoauthenticateontheprimaryand
secondaryHomeAgents.Thisisprovidedbyyourcarrier
orHAadministrator.
AT$QCMIPMHSPI
10. EntertheSPIrequiredbytheAuthentication,Authori‐
zationandAccountingserver.Thisisprovidedbyyour
carrierorAAAadministrator.
AT$QCMIPMASPI