User guide

Rev 3.0D Jul.09 13
3
3: Activating your Raven XT on
your cellular provider
• Activating Using AT
Commands
Thischapterprovidesstep‐by‐stepdirectionsforactivating
yourRavenXTonyourcellularprovider’snetwork.
H
Tip: If you want to use USB to activate the Raven XT, you will need to
install the USB driver first. Please refer to,
Installing the USB driver, in
Chapter 6.
Activating Using AT Commands
AnalternatemethodtoconfigureandactivateyourRavenXT
isbyusingATcommandssentdirectlytothemodemwitha
terminalapplication.
Caution: It is not possible to activate the Raven XT using either
Aceweb or AceNet.
1. Settelnettimeoutinto20minutes.
2. Savethetelnetsetting.
3. Entertheusernameofyouraccount(NAI).Theuser
nameisusuallyexpressedasanemailaddresswithphone
numberoftheaccount(example,[e-mail]).
Thisinformationshouldbeprov idedbyyourcarrier.You
maynotneedthisstep.
AT*NETUID=[NAI]
4. Enterthepasswordofyouraccount.Thisinformation
shouldbeprovidedbyyourcarrier.Youmaynotneedthis
step.
AT*NETPW=[password]
5. VerifyALEOShasestablishedcommunicationtothe
internalhardware.
6. Entertheactivationcommandappropriateforyourtypeof
account.TheSIDandNIDareoptionalandonlyrequired
ifyouraccounttypeusesthem.
· IfyouhavethesamenumberfortheMINandMDNor
MSID:
AT*PROVISION=MSL,MDN[,SID,NID]