User guide

Raven XT
141 20070914
Firewall Range
Youcandefinethreedifferentrangesofstartandend.AllIP
addressesbetweenthestartoftherangeandtheendofthe
rangewouldbeallowed.
Forexample,ifRange1Startwassetto192.168.13.50andthe
Range1Endwassetto192.68.13.95,thentheIPaddressof
192.168.13.10 0wouldnotbeallowedsinceitwouldbeoutside
oftherange;but192.168.13.75wouldbeallowed.
PortFilteringModeallowsonlythedefineduserportsandcan 
blockotherports.Portfilteringcan beconfiguredtoblock
connectionsonthespecifiedports(BlockedPorts),allow
connectionsonlyonthespecifiedports(AllowedPorts),ornot
blockorallowbasedonports(NotUsed).Eachspecifiedport
will
beallowedorblockeddependingonthePortFiltering
Mode.
Note: The Port Filtering is in addition to any port blocking or allowing
done by the cellular provider. If the port is blocked by the cellular
carrier, setting it for allowed here will have no effect since the
connection would be blocked before even reaching the Raven XT.
Port Forwarding
AnydatacominginonthedefinedPublicPortwillbepassed
tothecorrespondingPrivatePortconnectedtothephysical
interfacespecifiedandusingthehostIPaddress..
Note: This feature can be used only in private mode.