User guide

Configuration Commands
Rev 3.0D Jul.09 124
• n=1:On.
• n=2:UseTelnetservermodeonTCPconnections.
• n=3:WithaTelnetconnection,overridestheclientʹs
defaultecho,allowingtheserveronthehostportto
performtheecho.CRLFsequencesfromthe telnetclient
willalsobeeditedtosimplypassCRstotheserveronthe
hostport.
S7=n
SpecifiesthenumberofsecondstowaitforaTCPconnection
tobeestablishedwhendialingout.
S60=n
TelnetClientEchoMode.
• n=0:NoEcho
• n=1:LocalEcho(Default)
• n=2:RemoteEcho
S221=n
ConnectDelay:Numberofsecondstodelaythe“CONNECTʹ
responseuponestablishingaTCP connection.ORNu mberof
tenthsofsecondstodelaybeforeoutputtingENQonthe serial
portaftertheCONNECTwhentheENQfeatureisenabled
TCPS=n
TCPconnectiontime‐out(TCPS)units.Specifiesatimeinterval
uponwhichifthereisnoinoroutboundtrafficthroughaTCP
connection,theconnectionwillbeterminated.
UnitédudélaideconnexionTCP(TCPS).Spécifieledélaiàla
finduqueluneconnexionTCPsanstraficentrantou sortantest
rompue.
• n=0:minutes
• n=1:secondes
TCPT=n
IntervaltoterminateaTCPconnectionwhennoinor
outboundtraffic.
ThisvalueaffectsonlytheTCPconnectionin
TCPPADmode.
Caution: TCPT should never be 0 when using the TCP mode. A
broken TCP session can result in the modem being left with a TCP
half-open connection that can only be terminated with a reset.