User guide

Configuration Commands
Rev 3.0D Jul.09 122
• n=0:Fax/datacall.
• n=8:Normalinterconnect.
+WVCLASS?queriesthecurrentsetting.
+IPR=n
I/OPortRate:Setsthedataratefortheserialport(DTE‐DCE).
C3x11orC3x11Eonly.Defaultis115200.Cannotbeconfigured
inAceManager.
+WVLASS=n
ThiscommandsetstheRavenXTintoaparticularvoice‐mode
operation,whichcausestheinternalhardwaretoprocessinfor
‐
mationpresentedintheDialcommandinamannersuitable
forthattypeofinformation.Cannotbeconfiguredin
AceManager.
• n=0:Normalinterconnect(usingline1).
• n=9:Fax/datacall.
$QCVAD=n
ModeforansweringdataorfaxwiththeA(answer)orvia
autoanswer(S0=1).C3x10orC3x10Eonly.Cannotbe
configuredinAceManager.
*CTSE=n
ClearToSendEnable:ThisfeatureassertsCTSwhenthereisa
networkconnection.
• n=0:Disabled(Default).
• n=1:EnableassertionofCTSwhenthereisnetwork
coverage.
RS232voltagelevels:
Positive = Network coverage.
Negative = No coverage.
Tip: Flow control (AT\Q) will override this indication, so if you want to
use CTS to indicate network coverage, flow control has to be off
(AT\Q0).
*MODEMHISPEED
Settheinternalseriallinkspeedtotheinternal(radio)module.
• n=0:115200and38400foriDEN(default)
• n=1:230400and115200foriDEN
• n=0:115200(default)
• n=0:38400(default)