User guide

Raven XT
111 20070914
*HOSTMODE?
Thecurrenthostmode(AT,PPP,UDP,etc.).IftheRavenXTis
notinATmode,telnetintothemodemtoexecutethis
command.
*NETCHAN?
Thecurrentactive1x/CDMAchannelnumber.
*NETERR?
TheEVDOorCDMAnetworkframeerrorrate.
*NETIP?
Note: If there is no current
network IP address, 0.0.0.0 may
be displayed.
ThecurrentIPaddressofthemodemreportedbytheinternal
module,generallyobtainedfromyourcellularprovider.This
istheaddresscancontacttheRavenXTfromtheInternet.
Tip: Use *NETALLOWZEROIP if you need to allow the display of an
IP ending in a zero.
*NETOP?
Thecurrentcellularcarrierfromthemodemʹsfirmware
version,forexample,yourcellularprovider.
*NETRSSI?
ThecurrentRSSI(ReceiveSignalStrengthIndicator)ofthe
RavenXTasanegativedBmvalue.
Tip: The same information is displayed with the command S202?.
*NETSERV?
Thetypeofservicebeingusedbythemodem,forexample
Tech.
*NETSTATE?
Thecurrentnetworkstate:
• ConnectingToNetwork:TheRavenXTisintheprocessof
tryingtoconnecttothecellularnetwork.
• NetworkAuthenticationFail:Authenticationtothe
cellularnetworkhasfailed.Verifysettingstoactivatethe
RavenXT.