User guide

Hardware Installation of the Raven XE
Rev 2.0 Oct.09 23
Mounting
AnoptionalaccessoryforyourRavenXEisamountingkit,
whichincludesabracket.Thebracketisdesignedtosnugly
cradlethemodemandholditinplacewhereyouneedit.You
canuseastraparoundthebracketandmodemforextra
security.Thebracketcanbeattached
toastationarylocation
using#6screwswiththemountingholediameterapproxi
‐
mately0.150ʺ.
Theinstructionstobracketinstallationisfollowing:
1. Mountthebracketusingnumber6screws.Therearetwo
holeseach,tofastenscrews,andminimumofonehole
eachendisrequiredformountingbracket.
2. PositionRavenXEbetweenAlignmentears.
3. EngagetopgrooveinbodyofRavenXEwithtwotabs.
4. PushonfarsideofRavenXEincentersothatittouches
sideofBracket.
5. Pressdownandreleasewhenuppergrooveonfarsideof
RavenXE,alignswithtabs.
6. Releasetocompleteinstallationintomountingbracket.
Torem ove,pressonthetwoedgesofthemodemandthe
brackets,aspointedbyarrowsinthediagramprovidedbelow.
Bydoingthis,themodemwillsnapoutofthemounting
bracket.
Figure 4-6: Optional Mounting Bracket