User guide

Hardware Installation of the Raven XE
Rev 2.0 Oct.09 22
• Activity‐Lightswillflashasdataistransferredtoand
fromtheRavenXEontheremotenetwork.
• Power‐Indicatesthepoweradapterisconnectedand
thereispowergettingtotheRavenXE.
• TheResetbutton(ontheleftsideoftheRavenXE)hastwo
functions.Ifitisquicklydepressedandreleased,the
modemwillsimplypowercycletheinternalhardware.If,
however,theresetisdepressedandheldforseveral
seconds(countapproximately30seconds,andwaitforthe
power
lighttogooffafterthelightpatternstops),the
ALEOSconfigurationsettingswillreturntothefactory
defaults.
Light Patterns
TheLEDsonthefrontofthemodemwillrespondindifferent
patternstoindicatemodemstates.
• Normal‐EachLED,mentionedabove,islitasapplicable.
• Startup‐TheLEDswillcyclefromlefttoright.
• ConfigurationReset‐TheLEDswillcyclelefttorightand
thenrighttoleft4times.
• AuthenticationFailure‐TheNetwork,Signal,and
ActivityLEDsblinkevery2seconds.
• DataRetry‐TheNetwork,Signal,andActivityLEDsblink
every3seconds.
RSSI LED Ranges
RSSI/Signal LED
Status
Ranges of RSSI (dBm)
On Solid Equal to or stronger than -69
Fast Blink -70 to -79
Normal blink -80 to -89
Slow Blink -90 to -99
Extinguished Equal to or weaker than -100
Caution: If you reset the modem configuration using the reset button,
you may to reconfigure your APN.