User guide

Rev 2.0 Mar.10 15
3
3: Activating your Raven XT on your
cellular provider
• Activating Using AT
Commands
This chapter provides step-by-step directions for activating your
Raven XT on your cellular provider’s network.
H
Tip: If you want to use USB to activate the Raven XT, you will need to install
the USB driver first. Please refer to,Installing the USB driver, in Chapter 6.
Activating Using AT Commands
An alternate method to configure and activate your Raven XT is by
using AT commands sent directly to the modem with a terminal
application.
Caution: It is not possible to activate the Raven XT using either
ACEmanager or AceNet.
1. Set telnet timeout in to 20 minutes.
2. Save the telnet setting.
3. Enter the user name of your account (NAI). The user name is
usually expressed as an email address with phone number of the
account (example, [e-mail]). This information
should be provided by your carrier. You may not need this step.
AT*NETUID=[NAI]
4. Enter the password of your account. This information should be
provided by your carrier. You may not need this step.
AT*NETPW=[password]
5. Verify ALEOS has established communication to the internal
hardware.
6. Enter the activation command appropriate for your type of
account. The SID and NID are optional and only required if your
account type uses them.
· If you have the same number for the MIN and MDN or MSID:
AT*PROVISION=MSL,MDN[,SID,NID]
· If you have the different numbers for the MIN and MDN or
MSID:
AT*PROVISION2=MSL,MDN,MIN/MSID[,SID,NID]