User guide

Rev 1.0A Mar.10 28
• Go to: http://192.168.13.31:9191 the first time you connect to
ACEmanager.
An alternate method to configure and activate your PinPoint XT is by
using AT commands sent directly to the modem with a terminal
application.
Caution: It is not possible to activate the PinPoint XT using either
ACEmanager or AceNet.
1. Set telnet timeout in to 20 minutes.
2. Save the telnet setting.
3. Enter the user name of your account (NAI). The user name is
usually expressed as an email address with phone number of the
account (example, [e-mail]). This information
should be provided by your carrier. You may not need this step.
AT*NETUID=[NAI]
4. Enter the password of your account. This information should be
provided by your carrier. You may not need this step.
AT*NETPW=[password]
5. Verify ALEOS has established communication to the internal
hardware.
6. Enter the activation command appropriate for your type of
account. The SID and NID are optional and only required if your
account type uses them.
· If you have the same number for the MIN and MDN or MSID:
AT*PROVISION=MSL,MDN[,SID,NID]
· If you have the different numbers for the MIN and MDN or
MSID:
AT*PROVISION2=MSL,MDN,MIN/MSID[,SID,NID]
Using Direct Commands to the Internal
Hardware
Use only if the ALEOS method is unsuccessful.
Activating the Modem
1. Put modem into passthru mode to by-pass ALEOS. This will
allow direct communication with the wireless module for
programming. Entering passthru will take 10-15 seconds and
will return an ‘OK’ when it is complete.
AT\APASSTHRU
2. Verify you are in Passthru mode.
AT!STATUS
3. Unlock the module.
AT~NAMLCK=MSL