User guide

Rev 1.0A Mar.10 33
Figure 0-9: PinPoint XT Indicator lights
•Network - Indicates a successful connection to the cellular
network with an IP address given and a channel acquired.
•GPS - Indicates a GPS fix. When lit, the PinPoint XT has GPS
coordinates to report.
•Power - Indicates the power adapter is connected and there is
power getting to the PinPoint XT.
Light Patterns
The LEDs on the front of the modem will respond in different patterns
to indicate modem states.
• Normal - Each LED, mentioned above, is lit as applicable.
•Start up - The LEDs will cycle from left to right.
• PassThru mode - Network LED will blink.
•Low Power - All LEDs will be off except the power LED which will
blink every 3 seconds.
• Bad Firmware - The Network LED will blink.
• Incorrect Firmware - The GPS LED will blink.
RSSI LED Ranges
RSSI/Signal LED Status Ranges of RSSI (dBm)
On Solid Equal to or stronger than -69
Fast Blink -70 to -79
Normal blink -80 to -89
Slow Blink -90 to -99
Extinguished Equal to or weaker than -100
Caution: If you reset the modem configuration using the reset button,
you may need to reactivate your PinPoint XT with Sprint.