User guide

PinPoint Group
Rev 3.0C Apr.08 55
• nnnn=TAIPID(4characters)
*PPTCPPOLL=n
SpecifiestheporttolistenonforTCPGPSreportpolling.The
requesttothisportneedstocomefromthesameIPaddressin
*PPIP.
• n=0:Disabled
• n=1‐65535(default9494)
*PPTIME=n
GPSReportTimeInterval.Seealso*PPMINTIME,*PPTSV,
+CTA.
• n=seconds(1‐65535)
Note: Your cellular carrier may
impose a minimum transmit time.
Caution: A report time of less than 30 seconds can possibly keep an
RF link up continuously. This will eventually cause the your modem to
overheat and shutdown. An RF resource may continue be tied up to
transfer small amounts of data. Generally the RF channel will be
released and go dormant in 10-20 seconds of no data sent or
received.
*PPTSV=n
TimerforStationaryVehicles.Timeintervalinminutesthatthe
yourmodemwillsendinreportswhenitisstationary.
• n=0:Disabled
• n=1‐255minutes
Forexample,if*PPTIME=10,theyourmodemwillsendin
reportsatleastevery10secondswhileitismoving;however,
onceitstopsmoving,itwillslowthereportsdowntothis
*PPTSVvalue.
*UDPRGPS=n
SetorqueryGPSstampingofUDPReliablepackets.Whenset,
datareceivedonthehostserialportwillbeencapsulatedwith
theGPSdateandtime.
• n=0:Disabled(default)
• n=1:Enabled
*PGPSC
AllowsaPPtobeconfiguredtosendGPSsentencesoutofthe
serialportwhenthePPlosescellularcoverage.Thisfeatureis
configuredby2fields.Thiscommandcontrolsthestatusofthe
sentences.
• n=0:Alwayssent