User guide

Ace Manager
12 20070914
Tip: If you want to connect to your modem remotely, you will need to
make sure your computer can access the cellular network to which
you modem is connected. To test if you can reach the modem you
can Ping the IP or fully qualified domain name of the modem (i.e. if
you are using IP Manager).
Pingisacommandusedfromyourcomputer.Toping,open
upacommandpromptwindow(Start>AllPrograms>Acces
‐
sories>CommandPrompt)andtypepingwiththeIPaddress
orthefullyqualifieddomainnameofthemodem(i.eping
64.163.70.22orpingmodemname.eairlink.com).
SomecellularcarriersblockPingintotheirnetwork.Evenif
youcannotPingyourmodem,youshouldstillbeableto
connecttoitremotelyifitisregisteredandoperatingnormally
andhasanInternetaccessibleIPaddress.
Note: For all connection methods, the default password for the
modem (12345) will be entered. If you previously changed the
password in the modem, you will need to type in the changed
password.
Using UDP
Ifyourmodemisnotconnectedtoyourcomputerdirectly,you
canusethisoptiontoremotelyconnectthroughyourcellular
service.TypeintheIPAddressordomainnameofyour
modem(ifyouareusingIPManagertoconverttheIPaddress
toaname)andenterthepassword.
Ifyouhaveused
AceManagerbefore,youcanselectapreviouslyusedaddress
ornamefromthedropdownmenu.
IfyouhaveaSierraWirelessAirLinkmodemwithanEthernet
port,youcanuseUDPtoconnecttoyourmodemifitis
connecteddirectlytoyourcomputerwithanEthernetcable
(youmayneedacrossovercableforaRaven‐EorPinPoint‐E).
FortheAddress,
enterthe*PEERIPofthemodem
(192.168.13.31isthedefault)..
Note: If you use a firewall, the UDP port range 17300-17400 must be
unblocked to use UDP to send/receive data to the modem.