User guide

Ace Manager
8 20070914
• PacketLevelDiagnostics
• DeviceManagement&Control
• ProtocolSpoofing
Figure 1-1: Powered by ALEOS
Installing and Running
AceManager
AceManagerisavailableforfreefromAirLinkandcanbe
downloadedfromhttp://www.sierrawireless.com/support/
AirLink/Wireless_Ace.aspx.
Oncetheapplicationisinstalled,youcanrunitfromyour
Startmenuorfromtheicononthedesktop.
1. Start AceManager
Start>AllPrograms>AirLinkCommunications>AceManager
Note: AceManager requires the
Microsoft .NET Framework and
Microsoft Windows 98, Windows
2000, Windows XP, or later.
You can obtain the Microsoft
.NET Framework from Microsoft
at: http://www.microsoft.com/.
WhenyoufirstopenAceManager,theworkareawillbe
empty.Youwillneedtoconnecttoamodembeforeanyofthe
sidemenuoptionswillbecomeavailable.Connectingtoa
modemiscoveredinthenextchapter.
Tip: The AT Commands listed in AceManager are the same
commands you could use if you used Telnet or direct serial communi
-
cation to contact the modem. In some cases, though, there may be
fewer options available in AceManager. Only options available in
AceManager are covered in this guide. For all AT commands
available for your modem, consult the modem user guide.
Menus
TherearetwomenusforAceManager.TheConfiguration
Panel,availableatalltimesandforallmodems,andtheGroup
Tabswhichvariesdependingonthemodemmodeland
cellulartechnology.