User guide

Configuring the PinPoint X
Rev 2.0 Mar.10 39
• Optional parameters are denoted with square brackets [ ].
• AT Commands are not case sensitive. A capital “E” is the same as a lower-
case “e”.
• When you are using a terminal connection, if you enter a command which is
recognized by the PinPoint X, it will respond with “OK”. If the command is not
recognized, the response will be “ERROR”.
• Those commands applicable only to certain model numbers of the PinPoint X
will be noted.
Caution: Symbols listed with commands, such as *, /, &, or ?, are part of the command
and must be included. Commands with symbols other than * may require PassThru mode.