User guide

Activating your MP on the Verizon Network
Rev 2.0 Mar.10 25
Activating the Modem
1. Put modem into passthru mode to by-pass ALEOS. This will allow direct
communication with the wireless module for programming. Entering passthru
will take 10-15 seconds and will return an ‘OK’ when it is complete.
AT\APASSTHRU
2. Verify you are in Passthru mode.
AT!STATUS
3. Unlock the module.
AT~NAMLCK=MS L
Tip: The MSL is a six digit number that is unique to each modem.
4. Set the MDN and MSID.
AT~NAMVAL=0,MDN,MSID,0,65535
5. Verify the settings are what you intended to enter.
AT~NAMVAL?0
PassThru mode through AT Command
Issuing the “AT\APASSTHRU” from a terminal emulation enters the PassThru
mode. The modem responds with OK, at which point a direct connection to the
internal hardware is established. You can also configure the modem to enter
PassThru mode on start up using MD.
Figure 1-8: PassThru mode