Specifications

Testing

Rev 6 Mar.13 Proprietary and Confidential - Contents subject to change 77

7. Press Enter twice.

8. Use the down-arrow key to select Save setup as dfl.

9. Select Exit.

UMTS RF transmission path test

Note: This procedure segment is performed in Step 12 of the Production test procedure on

page 74.

Table C-1 contains parameters used in the suggested test procedure that follows.

To test the DUT’s transmitter path:

Note: This procedure

describes steps using the

"Power Meter: Gigatronics

8651A” (with Option 12

and Power Sensor

80701A).

1. Set up the power meter:

a. Make sure the meter has been given sufficient time to warm up, if

necessary, to enable it to take accurate measurements.

b. Zero-calibrate the meter.

c. Enable MAP mode.

2. Prepare the DUT using the following AT commands:

a. AT!ENTERCND=”<password>”(Unlock extended AT command set.)

b. AT!DAFTMACT (Enter test mode.)

c. AT!DASBAND=<bandValue> (Set frequency band.)

· See Ta ble C-1 for appropriate <bandValue> values

Table C-1: Test settings — Transmission path

Mode

Test