Installation Guide

2–16 HP Broadband Wireless Module Installation Guide
Installing the HP Broadband Wireless Module
DRAFT Revised: 6/27/07
File: Chap2.fm
PN: CPQ-CPQ Part Number HP-416484-002 U-Unbranded Part Number
hp CONFIDENTIAL
Ä
CAUTION: Do not pull on an antenna cable to remove it. Gently grip
and pull only on the connector itself. Pulling on the cable can damage
the connector or break it off the cable.
5. Carefully disconnect the 2 wireless local area network
(WLAN) module antenna cables (labeled with the numbers 1
and 2) by lifting the cable connector(s) with your fingernails
or a small screwdriver.
If your computer has a wireless module currently installed, you
must remove it before installing the new module. Refer to
Chapter 4, “Removing an HP Broadband Wireless Module.”
After you remove the existing module, resume this procedure
at step 8 to install the new module.
416484-002.book Page 16 Wednesday, June 27, 2007 4:08 PM