User guide

IPsec User Guide
14 2120028
Figure 2-5: PinPoint Configuration
2. Providethe Server IP Addressontheright‐handsidepane.
3. Enterth
eReport Interval time.
4. Configureth
e IPSec Interface parameteras“1”,toenable
IPSec.OnceIPSecisenabled,thefactorydefaultsettings
shouldberestored.Table2‐1li
stsalltheIPSecparameter
defaultva
lues.TherequiredfieldsforIPSectobeestab‐
lishedare:
a.
IPSec Gateway
b. Pre-shared Key 1
c. IKE Encryption Algorithm
d. IKE Authorization Algorithm
e. IKE Key Group
f. IKE SA Life Time
g. Remote Address
h. IPSec Encryption Algorithm
i. IPSec Authentication Algorithm
j. IPSec Key Group
k. IPSec SA Life Time
l. Incoming Out of Band:Ifyouwantmobiletermination
m.
Outgoing Host Out of Band:Toaccessinternetoutsidethe
tunnel,fromthemodem.
5. Clickon
Write.
6. Clickon
Reset,toresetthemodem.