User guide

Configuring the AirLink GX400
Rev 1.0 Jun.11 37
• Most commands with parameters can be entered with ? to read the current
value. (For example, AT& D? will respond with “2” if the default has not been
changed.)
• Optional parameters are denoted with square brackets [ ].
• AT Commands are not case sensitive. A capital “E” is the same as a lower-
case “e”.
• When you are using a terminal connection, if you enter a command which is
recognized by the AirLink GX400, it will respond with “OK”. If the command is
not recognized, the response will be “ERROR”.
• Those commands applicable only to certain model numbers of the AirLink
GX400 will be noted.
Caution: Symbols listed with commands, such as *, /, &, or ?, are part of the command
and must be included. Commands with symbols other than * may require the Passthrough
mode.