Network Router User Manual

Global Positioning System (GPS)
Rev 3.0B Feb.08 93
Tip: Setting up the serial port hardware is covered in the Inputs,
Relay Outputs, and Power Status chapter.
AfteryouenableRTSIand/orDTRIaccordingtowhichyou
havewiredtoyourexternaldevice,youwillalsoneedto
enabletheeventreportingwith*PPINPUTEVT.
Figure 9-21: AceManager : PinPoint - RTSI, DTRI, *PPINPUTEVT
ThereporttypewillindicatethestateofchangeineitherRTS 
orDTR.ThecontentsofthereportwillbethesameasReport
Type0x12(GPSdatawithdate)withtheadditionoftheevent
report.
Tip: If you have connected the physical device to the RTS pin and
ground, you will need to enable RTSI. If you have connected it to the
DTR pin and ground, you will need to enable DTRI. If you have
devices connected to both, enable both.You can have different
devices connected to each.
COM1000support
SupportforaCOM1000isenablewiththecommand
*PPCOM1000=1.Onceenabled,ALEOSwillreceivethereports
fromaproperlyconfiguredCOM1000andaddthestateofthe
extrainputstoRAPpacketssenttotheRAPHost.
Figure 9-22: AceManager : *PPCOM1000, *PPREPORTINPUTS
Thereporttypewillindicatethestateofchangeintheinputs.
ThecontentsofthereportwillbethesameasReportType0x12
(GPSdatawithdate)or0x13(GPSdatawithdateandRFdata)
withtheadditionoftheeventreport.
FlushonEvent
IfyouhaveStoreandForwardconfiguredandenabled,to
receiveeventreportsimmediatelywhentheyoccur,youwill
wanttoenable*PPFLUSHONEVT.Thiswillcauseallpending
reports,includingthetriggeringevent,tobesentimmediately
totheHost.