Network Router User Manual

Configuration Commands
Rev 3.0B Feb.08 144
• n=minutes
*TPORT=n
Setsorqueriestheportusedfor theATTelnetserver.If0is
specified,theATTelnetserverwillbedisabled.Thedefault
valueis2332.
• n=0:Disabled.
• n=1‐65535
Tip: Many networks have the ports below 1024 blocked. It is recom-
mended to use a higher numbered port.
*TQUIT
Disconnectsthetelnetsession.NotavailableinAceManager..
Low Power
ThePinPoint‐Ewillputitselfintoalowpowerusingmode
whenconfiguredeventsoccur.LowPowermodeisessentially
astandbymodewhichusesminimalpowerwhilebeingready
to“comealive”quickly.
Figure 1-15: AceManager : Low Power
DTRP=n
SetorquerytheDTRpowercontrol.SeealsoPTMR.
• n=0:IgnoreDTRforpowercontrol.
• n=1:EnterlowpowermodewhenDTRislow.
• n=2:EnterlowpowermodewhenDTRishigh.
PTMR=n
Numberofminutesafteroneofthepowerdownevents(VTLG
orDTRP)happensuntilthePinPoint‐Eentersthelowpower
mode.IfDTRPandVLTGareboth0(zero),thissettingdoes
nothing.