Network Router User Manual

Configuration Commands
Rev 3.0B Feb.08 130
Figure 1-8: AceManager : UDP
AIP=n
AllowIPaddress.
• n=0:AllowonlytheIPaddressspecifiedinS53toconnect
whenUDPautoanswerisenabled(S82=2).
• n=1:AllowanyincomingIPaddresstoconnectwhen
UDPautoanswerisenabled(S82=2).
Note: Always subject to any Friends filters that may be defined.
HOR=n
Half‐OpenResponse‐InUDPautoanswer(half‐open)mode.
• n=0:NoresponsecodeswhenUDPsessionisinitiated.
• n=1:RINGCONNECTresponsecodessentoutseriallink
beforethedatafromthefirstUDPpacket.
Note: Quiet Mode must be Off.
MDhh
Defaultpower‐upmodefortheserialport:WhenthePinPoint‐
Emodemispower‐cycled,theserialportentersthemode
specifiedbythiscommandafter5seconds.Onstartup,typing
ATMD0within5secondschangesthemodetonormal(AT
command)mode.SeealsoS53tosettheport
forUDPorTCP.
• hh(hexbyte)=00:normal
• hh=01:SLIP
• hh=02:PPP
• hh=03:UDP
• hh=04:TCP
• hh=07:PassThru
• hh=0F:PinPointMDT