DART 200 CDPD Modem User's Guide

DART 200 CDPD Modem User’s Guide 5 DART Supported Protocols
PN1197-00 Revision 1.0 5-13
Table 5-2. Host UDP setup
AT Command Req Opt Def Description
AT^Annn.nnn.nnn.nnn
R
Input IP Address (if not already done)
AT\N[1,2]
R
Side Preference - (get from carrier)
AT\J0
D Use default - No channel access
restrictions
AT\R4
R
Auto Registration at Power On
ATS13=0
R
With AT\R4 sets Continuous
Automatic Registration
AT\O0
R
PAD mode required for UDP.
AT*A0
D Use default - No server function
required
AT*L2100
D Use default - Listen on port 2100
ATS82=0
R
Turn off backward compatibility.
ATE0
O
No command mode character echo
ATV0
O
Use terse result codes
ATQ0
D Use default - Result codes are sent to
the host
ATF1
D Use default - Do not echo transmitted
data to the host
ATX1
D Use default - Extended result codes
AT&C1
D Use default - DCD follows state of
the connection
AT&D0
D Use default - You may want to
consider using DTR to escape
AT&E2
O
Filter escape sequence from output
AT&S0
D Use default - DSR is always active
AT\F3
D Use default - Applies only if \M1
specified
AT\M0
D Use default - Do not recognize data
forwarding characters
AT\Q2
D Use default - Most PC’s use flow
control
AT\T1
D Timed data forwarding - Always use
with binary data
AT*B0
D Use default - Many CDPD Carriers
have not implemented Broadcast.
AT*C1
D Use default - Does not apply to UDP
AT*G1
D Use default - Does not apply to UDP
AT*K0
D Use default - Does not apply to UDP
AT*R0
D Use default - Does not apply to UDP
AT*T0
D Use default - Does not apply to UDP