User guide

AirLink GX400 for Verizon User Guide
26 2140712
Figure 3-2: Confirm IP Address
Configuring Through ACEmanager
ACEmanager is a free utility. Follow the steps below to connect to ACEmanager
and begin configuring the device.
• Ensure that the AirLink GX400 is properly connected to allow access to the
ACEmanager user interface.
• Go to: http://192.168.13.31:9191 the first time you connect to ACEmanager.
Connecting the Antennas
Warning: This device is not intended for use within close proximity of the human body.
Antenna installation should provide for at least a 20 cm separation from the operator.
Antennas selected should not exceed a maximum gain of 4.55 dBi in Cellular
Band and 2.85 dBi in PCS band under any standard installation configuration. In
more complex installations (such as those requiring long lengths of cable and/or
multiple connections), it is imperative that the installer follow maximum dBi gain
guidelines in accordance with the radio communications regulations of the
Federal Communications Commission (FCC), Industry Canada, or your country’s
regulatory body (if used outside the US).
Your AirLink GX400 will work with most cellular antennas with an SMA connector.
Connect the primary antenna or primary RF cable directly to the antenna
connector on the back of the AirLink GX400.